United States Stamps

PEM HNF9 Stamped 9 Ford Center Housing, new

PEM HNF9 Stamped 9 Ford Center Housing, new
PEM HNF9 Stamped 9 Ford Center Housing, new
PEM HNF9 Stamped 9 Ford Center Housing, new
PEM HNF9 Stamped 9 Ford Center Housing, new
PEM HNF9 Stamped 9 Ford Center Housing, new

PEM HNF9 Stamped 9 Ford Center Housing, new
PEM HNF9 Stamped 9 Ford Center Housing, new. Are you tired of stripping down an old rusty housing? Have you run out of burn ointment after cutting and grinding the tubes off, so you can weld new tubes in your rear end housing? Performance Engineering & Manufacturing, LLC. Has developed a new HNF9 stamped 9 Ford center that is ready to just slip in your 3 inch O.

Axle tubes (some grinding for fitment needed) and build a rearend housing. These fit 2.89, 3.062 and now also 3.25 carriers. The PEM HNF9 Center was approved on April 9, 2008 by IMCA for use as an OEM replacement part.

This center weighs 18 lbs. 21 wide at the longest part of the center housing There is greater tube weld contact area on the slotted housing, plus internal gussets for more strength. This also reduces tube and center flex. Ground reinforced face plate so your gear chuck slides right in.

No need for that big hammer! Auto racing is a hazardous sport. The item "PEM HNF9 Stamped 9 Ford Center Housing, new" is in sale since Thursday, April 13, 2017. This item is in the category "eBay Motors\Parts & Accessories\Performance & Racing Parts\Auto Performance Parts\Driveline & Transmission\Rear End". The seller is "pemracing" and is located in Saint Clair, Missouri.

This item can be shipped to United States.

  • Manufacturer Part Number: HNF9
  • Placement on Vehicle: Rear
  • Warranty: No
  • Country of Manufacture: United States
  • Brand: PEM Racing


PEM HNF9 Stamped 9 Ford Center Housing, new